Chain [strong, print in place]

Description

Chain [strong] Print in place. Supports are only needed for the closure areas (use supportblockers for the rest). Use 0,2 mm layerheight 20% infill is ok, more will make it even stronger. Will fit around sth. with 180 mm circumfence e.g. a wrist.Just connect two of them to double the length, may fit around the neck. Elements are 12 mm thick. Scale to your needs, but I recommend to let the z-factor untouched, since this affects the necessary z-gap. Once the pressfit-pin closes the chain, it will be hard to find it and open it again. Use some glue to make it permanent or a padlock to create a pair of Handcuffs. Have fun!

Statistics

Category

Tags