6-Bolt Bicycle Rotor Holder
Description
A holder I designed for 6-bolt bicycle rotors. It might make sense for you to make multiple holders to separate each rotor type. It's pretty rare for our shop to need a loose rotor so I just keep a single stack and shuffle through them. I added a 5 degree angle to the base so they could be attached vertically but they will work on a flat surface just fine. I went with Siraya Tech's Mecha White resin because its much more resistant to sliding friction than other resins I have tested and this part wont be seeing any other forces. Print time took about 10 hours. A large part of this is the long resting time after retraction. You can shorten this all the way to zero but the surface finish will be awful.
Statistics
Likes
0
Downloads
0