Modix Big 60 Primary Fan Bracket
Description
This bracket replaces the aluminum hotend fan mount bracket on a Modix Big 60. NOTE: USE AT YOUR OWN RISK. The original bracket is aluminum, and when you crash the print head, the bracket bends but stays attached. This bracket will snap off, and the fan will be left dangling by the cord, which will most likely cause it to get snagged and ripped off. I'm currently thinking about a version that attached a piece of wire (e.g. paper clip) between the upper arm and the fan portion, so that if it were to break it would stay attached.
Statistics
Likes
0
Downloads
0