Walksnail VTX and Antenna Mount for Apex HD Frame
Description
Walksnail VTX and Antenna Mount for Impulse RC Apex HD Frame I made this very particularly so I could access reset switch and usb connection on side for easy firmware upgrade for the Walksnail VTX. Allowing for VTX antennas, and Crossfire/ELRS antenna(lower rear rings) mounting. The VTX can only sit one way with the camera connections facing towards the front of the Apex frame, and the VTX reset switch facing towards the rear. It is a snug fit and doesnt need reinforcement to hold down, else use rubber band(or something), or I can make some kind of a top/hold down for the vtx if enough people would like it. Unless you are skilled removing support debris you may have to block out supports for lower internal antenna tube, as its hard to remove support here. If your printer has good bridging I would suggest only building supports from the plate.
Statistics
Likes
1
Downloads
0