Miraak inspired Mask, Shoulder Pads, Belt buckle, and Arm Bands
Description
This is a work in progress and does require a fair amount of faff post print to get it all working! Mask and mouth is a tight fit was designed to use magnets but I ran out of time. I used small screws with loops I drilled into the inside of the mask to attach the ribbons. Shoulder pads attached with Velcro tape. The arm bands are printed flat then I heated them with a hair dryer and molded them around a big stick about the size of my arm.(e.g. in images) The belt is printed in 2 parts for ease of printing just glue the connector on after.You may have to resize the attach point for the belt depending on how thick your belt is.
Statistics
Likes
0
Downloads
0