PS Vita 1000 charging dock station stand with LED capability
Description
PS Vita 1000 charging dock station stand with LED capability On photos first version of this dock station, after that is was slightly improved to make it possible to print more easily with minimum supports, but the main points have not fundamentally changed, so it is possible to approximately estimate from the photos what can be obtained in the end. To use it you'll need to print 4 parts: - vita_led_dock.STL - led_stand.STL - back_cap.STL - partofAletter.STL Also you'll need: - plexiglass peace ~90x18x2mm (can be a little bit less, but not more, use sandpaper to grind off excess if it'll not fit). It's needed to glue "partofAletter" part to dock - PS Vita 1000 crarging cable - WS2812b or similar adressed LED stripe - Arduino or similar adressed LED controller - some wires to connect controller with LED stripe <iframe width="640" height="480" src="https://www.youtube.com/embed/eV8zrEcbpoM" title="PS Vita DIY charging dock station with LED lights" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>
Statistics
Likes
0
Downloads
0