Stromberg Carburetor Tool S-353
Description
Stromberg Carburetor Tool S-353 I saw this... https://www.mgexp.com/forum/mg-midget-forum.3/make-your-own-zenith-stromberg-carburetor.2165252/#msg-21252 So I made this. You will have to drill a small hole for a 1/16" pin to lock into the notch on the carburetor damper piston cylinder. My pin was a cut off section of finishing nail. I was able to use some CA glue to secure the pin. One pin to interlock is enough. The Allen wrench is 1/8" and the hole down the center will most likely have to be drilled out to allow the Allen wrench to spin freely. Harbor Freight carries a kit with an 1/8" Allen that is long enough for around $7 USD I printed using ABS 100% infill and it takes about 1.25 hours to print.
Statistics
Likes
0
Downloads
0