Yeah Racing Capra 3rd Member spacer
Description
The Yeah Racing Capra 3rd Member wasn't designed to fit correctly. If you tighten the screws all the way the bearings will lock up. This spacer goes between the 3rd member and axle housing and allows you to tighten the screws without locking up the diff. You can still over tighten the 3rd member so snug it up but dont over tighten it NOTE: This spacer is undersized which makes it tough to get in place but once in place it should stay put while the 3rd member is installed. If this gives you trouble try scaling the print up a tiny bit. I tried flexible filament PLA and PETG and the PETG worked best because its solid but flexible. PLA snaps and flexible filament was just too soft.
Statistics
Likes
0
Downloads
0