LTT Screwdriver Bit Holder
Description
This is a very early WIP - I've tried to get measurements correct but I don't yet have the final item so it may be off. (let me know in the comments!) Space for 16 bits, each space has a 5 x 2mm round hole for a magnet to be glued into, to hold each bit securely. (can buy these from Amazon) Thinking of adding a couple of holes on each side for more magnets, to allow a modular design to stick boxes together for more bits. Let me know what you think, what needs changed etc. Print with at least 15% infill - the more the heavier. .20mm should be sufficient for quality. PLA should be more than enough for this.
Statistics
Likes
9
Downloads
0