Simply Smooth
Description
- With this design it was able to be designed with a thin light mold - Insert-able length is 133 mm (5.25"), Average Shaft Diameter at its largest is 45 mm (1.77"), Ball width 67 mm (2.64"), it also has a suction cup option - mold volume 290 mL ( 8.9 fluid oz) - Each has a mold and the actual pecker itself depending on how you are going to mold them. - mold has location for locating bolts 10mm, 5mm and 3mm - can be scaled, cut and glued together to any size you want - Use Platinum Cure Silicone, Shore Hardness 10 = firm, 5 = Medium (ish), 3 = soft. - Smooth-On is a good source: "Dragon Skin 10" for firm, "Ecoflex-00-50" for medium and "Ecoflex 00-30" for soft ___________________________________________________________________ - for a quick and dirty toy (will have flashing that needs to be cleaned up) you can use the 3d printed molds - You could also sand and clear coat the mold halves, using Vaseline to seal the halves (note: silicone touching Vaseline will not set so make sure it doesn't squeeze into the mold cavity during assembly. So don't use too much in other words) - Print with thick walls ex: 4 layers or more with 8% infill - if going the wax route you will loose detail and don't let the molten wax sit in the mold too long, it softens the plastic ________________________________________________________________ - you can also just print the dick it self, sand it smooth, seal and make a mold the old fashion way, use this way for the best results. ______________________________________________________________ - I recommend printing vertical if possible to get the resolution. - pour the silicone to just bellow the surface then right at the end of the pot life smush the top on and add a weight to keep it from moving - a good resource for silicone toy making: https://vimeo.com/candiru - Have Fun!!
Statistics
Likes
4
Downloads
0