Creality Spider Hotend Fan Cover - Ender 3 V2 - Dual Vent Remix
Description
The original design by Creality was only single sided vent and the fans flopped around. Did not print well without supports. Requires no additional hardware, only the original Ender 3 V2 fans (and of course a Creality Spider hotend) In this remix: ========== Vents on both sides of the nozzle for more even cooling. Single part fan only. Air duct running through the body for the left vent. The size is the same as the original, Version 3 properly seats the part fan and provide a better seal. **Version 3 (14/08/2022)** Increased ducting cross section. Added back the original part fan inlet cover. Changed cutout for base of part fan to seat properly into the holder. Much better part fan seal and increased air flow. The part fan should be properly located so it sits with the top of the fan flush to the top of the fan cover body. **Version 2** You will have to get inventive with version 2 to keep the part fan pinned down with a reasonably good seal. This version left here as some might find it more mod friendly
Statistics
Likes
0
Downloads
0