TUSH2 - A simple sliding re-remix
Description
Model has been moved to **Printables.com**: - https://www.printables.com/model/153227 I just receive the MMU2S (my journey is starting… I know) so I need to adapt my workspace. I love this sliding remix of the TUSH2 (here) and I used it as my main spool holder for all my print but some detail were bothering me so I corrected them: - **3mm nuts** are now **placed inside** the spool, rather than popping outside. So you can pack spools side by side satisfyingly. - **3mm nuts** were not hold in position properly in the original version, now it is a satisfying **very tight fit** (use a clamp). Nuts will never turn again. - Now, If you use a **3mm bolt** of **length 12mm**, It will not stick out of the TUSH2, as it was [slightly] the case in the previous version. - The **sliding rail** length has been **increase to 24cm** and supported with 3 small screws. This change was important to me: MMU2S = 5 spools. You can print many of them on the prusa bed at once. - Sliding rail **tolerance has been increase**, should be easier to slide. - I **dropped the arms** support system, going back to a plain design without any hole.I never used them in my previous versions. THIS IS A REMIX FROM A THINGIVERSE MODEL: https://www.thingiverse.com/thing:2853619 Edit: 01/04/2022: It was suggested in the comments/makes to reduce the scale of the Rail to 95% to allow better slide with no resistance. According to what you want, i.e. tight slide or easy slide, you might want to follow that advice. Thanks !
Statistics
Likes
0
Downloads
0