Egg Bracelet
Description
Literally the worst thing I will ever make. ===Assembly Instructions=== Required crap: 1. Supports are needed for eggHold and bandBottom, and also extremely difficult to remove, I might figure something else out but for now I really don't care. 2. The bracelet was designed for a M3 bolt and nut (bolt 20mm long), but I'm sure you could fit some alternative. 3. The bolt should be tightened so that the top piece is able to move with some resistance. 4. Yes, the clasp and clips fit together and Yes, it is really difficult. Optional crap: 1. The band clasps and clips are optional, you can just slip 2 rubber bands in the bottom. 2. The rubber bands needed are to be at most 3mm wide and 1mm high, the length of the band does not really matter. 3. bands are not required If I missed anything or anything is confusing, just comment and I may make an assembly video.
Statistics
Likes
0
Downloads
0