2D Mammoth
Description
It's very small by standard so I would definitely make it bigger. I would recommend turning it 90° so it lies horizontally. I made a smaller model, and just decided to do a durability test, but when I tried to snap it in half it was near impossible. The only thing I could break in my hand was the trunk, everything else was very hard. I had to put it on the edge of a table and push down towards the ground to snap it in half. But I would imagine that with a bigger model it could snap easier. The model looks a little glitchy in Cura (probably in other slicers too,) but it prints out like in the picture showed.
Statistics
Likes
0
Downloads
0