Printing support strut 45degX1mm
Description
I was printing a part that needed just a tiny bit of support, and instead of adding full support everywhere, I wanted to add a little cylinder as a strut for the unsupported corner. Instead of freehanding the angles in PrusaSlicer's plater's AddPart/Cylinder I thought I'd draw a strut with good bevels on the ends. The end bevels make it easy to freehand a good intersection with a part in a slicer. In the printed part, you could leave it attached, or you could cut it free By itself, this unsupported 1mm pin at 45 degrees is also a quick test of leveling and adhesion. It should be customizable in Thingiverse
Statistics
Likes
0
Downloads
0