TBS Podracer complete build 4 and 5 inch
Description
go easy, this took me a long time!! i crashed my podracer and the only way to get it back in the air was buy a whole new kit for the lower part that broke! so i decided to try and remake it, i then decided why not just make it all. As far as i can tell this is nearly perfect though it may need a little tweaking! im sure some of the holes in the mid plate may be a little off. I also included a slightly taller canopy as my wires didnt quite fit under the stock sized canopy that exists. print 100% infill, pla should be fine but asa or abs would be better. the arms are usually pretty solid so if you have the carbon arms id use those unless you just want to print a whole quad then go wild! supports needed on the canopy only.
Statistics
Likes
0
Downloads
0