Stand for Flexy Bat
Description
I just threw together this stand to be able to show off the MatMire Makes Flexy Bat in its hanging position. I did print this on a CR-10 Smart Pro so its a 300x300 build plate. I am sure you can tinker/remix and cut this up, but I only intended it to fit my needs orignally. It could have just been single stands that you print and distance however you like, but I didn't want to mess with balance and figured worse case I would tape or clamp it to the table which is why I put the bottom center bar in. The hole in the top is 2mm and fit a standard wooden kabob stick I happened to have in my kitchen. They are also super cheap at stores for an entire pack of them and can be painted easy. You could always run a cord through it or something instead. Hopefully it helps someone somewhere same sometime at very least, just thought I would share. It's my first post so be gentle!
Statistics
Likes
0
Downloads
0