Lightsaber Blade cap TPU (for collapsing lightsaber)
Description
Print in TPU I used supports everywhere @ 20% As is you have to pull it apart after it prints, and I like it that way. Also this was made for the heavy hilt, don't know if that maters but now ya know. Obi-wan cap was a pain to figure out a way to grip the flap, I ended up with a belt buckle type design. This was again printed using tpu and supports on. I used support blockers everywhere except for the flats. stringing was bad, but my tpu is horrible so hopefully not a problem for you. if it is a problem, a soldering iron makes quick work of that. Leia's blade cap has a thumb flick to release the blade, same as the first.
Statistics
Likes
1
Downloads
0