Cable Support Ortur Laser Master 2 Pro
Description
It bothered me that the cabling of the laser module on the Ortur Laser Master 2 Pro was sagging. Sometimes the (lighter) material placed under the laser was touched by this and also shifted. I have therefore constructed a cable support for the OLM 2 Pro. The connecting cable now rests on this support and the working area of the laser always remains free :-)) Since the cable support is about 50 cm long, I had to split it because otherwise it would not have fit on my 3D printer. I then glued the two parts together with the connector and super glue. The support is fixed with two M3 x 8mm screws. I attached the cable holder to the laser module carriage with two M8 nuts. The connecting cable is fixed with five cable ties.
Statistics
Likes
0
Downloads
0