Anycubic Kobra 5015 fan duct
Description
This a 5015-fan mod for the anycubic Kobra it uses the stock location of the original fan so is more discreet and uses the empty space in the mount. Fan- sunon MF50152VX-1L02C-A99 (Current known fan that will adjust fan % speed) Other fans may only work at 100% To install, place painters' tape on the face of the fan and position fan in the eletronics case and press down to make marks on the tape, then separate the case of the fan and use a 3/32 drill bit and make your holes. Note the plastic is soft enough to drill it by hand. Reuse the 3 m2 screws (omit the m3) from the original fan and mount the one half of the case. Then snap the other half of the fan to it then you can slide the duct onto the fan and snap the duct supports onto the original fan holes.
Statistics
Likes
2
Downloads
0