Clevo P770DM
Description
This is a remix of the P775 Feet for permanent or temporary attachment to my P770DM. The original was covering up some of my vents and was just too big. I took the original into Tinkercad and made it smaller in the X and Y Axis until the big end was the size of the old small end. Then I took a negative of the cutout and put it back in so it would fit over the laptop feet. I made the well 3mm deep so the original feet should fit inside depth wise. (see below about the size of the feet.) I recommend flipping it upside down and making a mirror copy for the other side foot. Also it is a little bit too small on the hole to fit over the laptop's foot, maybe scaling it 1-2% would work. I didn't worry about that because: I used some thick 3M UHB double sided adhesive strip to attach it permanently. And some foam rubber furniture anti-slip for the bottom side. Printed in PLA on Ender 3 small end down (no support needed) 0.2mm layer height 20% infill Scale up 1 or 2% if you want it to fit over the foot.
Statistics
Likes
0
Downloads
0