Parametric Display Stand (Plate/Book/Art/Tablet/Phone)
Description
This is a parametric display stand. You just need to specify how thick the thing you want to hold is, and what angle you would like to see it at. Features: - Simple, elegant, design. - Multiple sized stands will look the same. - Has bolt down holes, to secure it to a surface. - Will fit an item exactly; which lessens strain on the item. Paramaters: - **item_depth** How thick the item to be held is (mm) - **width** (mm), how wide the stand is - **support_depth** depth of rear support leg (mm); using about 45% of width looks good. - **height** How tall the stand is (mm). - **angle** Angle at which the item is held (from vertical) (deg). - **base_h** Height of the support platform underneath (mm) - **preview** True to remove rounded edges for a slicker appearance. - **plate_mode** True to make the stand better suited to holding plates (also, set height to the plate radius). Note: you probably want to run this in OpenSCAD, not the web based customizer.
Statistics
Likes
0
Downloads
0