FIghter Jet Throttle Grips for Logitech/Saitek Throttle Quadrant
Description
For those of you who own a Logitech/Saitek throttle quadrant and want a fighter-jet style throttle, here it is. I suggest printing with the inner (flat) sides down to minimize supports required. You will need a hobby knife and a small pair of needle nose pliers or rotary tool to remove the supports from the interior of the throttle shaft. These should fit somewhat snugly down over two adjacent throttle levers (left and middle or middle and right), similar to the interchangeable grips that are included with the throttle quadrant. They also raise the grip level so that the throttle grips are significantly higher than the third lever, so the third lever isn't in the way. Tolerances are WIP.
Statistics
Likes
0
Downloads
0