Ender-3 V2 Front Electronics Housing | Remix
Description
This is a remix from user @Pedrolamas What I noticed right away was that the back screws used to secure the top are in an akward position. They either didn't line up, or were barely reachable. I ended up just using the front screws and leaving the back screws out. What I changed: - Changed the back screw design to a slide system. There are no more screws in the back. - Added another fan cutout to the right side for the Raspberry Pi. - Turned the position for the Raspberry Pi 90 degrees. - Made a cutout on the left and right top guides, to accommodate for the fan so the top can sit flush. - Made a cutout for the Z-axsis and Z end switch wires to go to the motherboard. - Reinforced the back for more rigidity. - Reinforced the front for more rigidity. - Moved the fan position to accommodate for the micro usb port on the motherboard.
Statistics
Likes
0
Downloads
0