AIO box mod
Description
fix for those cracked tops on the original aio...Please dont forget to tip your designer .even if its a buck..Im sure many are searching for this...... this is not a easy project to do.. you must be decent with taking things appart and putting together..some screw holes need to be drilled out a little bit and some glueing .. you have to basically break your old mod appart to do this.. the bottom gold plate is basically pressed in the old mod and has to be cut out and so do the 3mm magnets if you reuse them and make sure you put them in the proper north south way.. you can use your original panels with this.. i did different versions to make it up to you which one will print easy for you and also breathing hole design.. I use vented cover panels so i didnt need breather holes.. print a cover panel without top and bottom layers and only see outline and infill...i printed this in asa filament and 2pc design so i had nice flats on the bed.. i had 3mm rod i cut into 4 pcs and used as guide as i glued it together.. it is not a perfect model but its pretty darn good,, you will have to press things in and drill screw holes cause they are tiny about 3 and glue inner cover panel in .. also it is a little bigger over all on outside dimentions by about 3mm give or take.. be careful while taking the button off..its like a sticker and peel it off slow and easy,, i used exacto knife and also allowed room for doouble sided tape to put it back on other wise the button is recessed by about a millimeter or so if you dont use double sided tape... I designed this from scratch im not a pro,, I got sick of waiting for warranty on my mod after 2mo and no response, and decided the guts are good so why not...
Statistics
Likes
0
Downloads
0