Graflex 4x5 Spring Back Film Holder Frame
Description
I had purchased a Graflex Crown Graphic that was missing many parts. One of the missing parts was it's spring back film holder. Because I had another 4x5 Speed Graphic, I had a frame to use as an example to design a copy. Some of the details were a bit intricate, so it was a challenge to do with my design skills in Tinkercad. Also, because there were details in both the top and bottom side, I decided to print it in two pieces so I could limit the support needed. The two parts are then glued and screwed together. It is a straight forward print, and I used PLA as the material to build with. I don't know enough about the various 4x5 Graflex cases to know if this will fit every model, but it worked on my 50's version of Crown Graphic.
Statistics
Likes
0
Downloads
0