Brazillian TUSH Holder (a gridfinity spool holder)
Description
As a woman of a certain age, I realized that my [TUSH](https://www.thingiverse.com/thing:2047554) needs a little extra support. I tried supporting my TUSH with [conventional methods](https://www.thingiverse.com/thing:4645143/files), but I noticed that throughout the day my TUSH would make quiet "clapping" noises as it wobbled back and forth; it is quite embarrassing. With the help of Mr. Freedman's [gridfinity](https://www.youtube.com/watch?v=ra_9zU-mnl8) system I designed something that could accommodate my needs. Since this is only the first version, I decided not to name this "infinity tush holder" to reflect its full integration with the gridfinity system. However, it does seem to work quite well, so I chose a number which is close to infinity: a brazillian. The "H" shape of this part is to facilitate nesting a 1x1 gridfinity bowden bulkhead, the design of which is to be released later. Parts needed: 2x m3 16mm screws (optional - works fine without) 1x [completed build of the adjustable TUSH stand](https://www.thingiverse.com/thing:4645143/files) (requires 1x 608 bearing) 1x [completed build of the TUSH](https://www.thingiverse.com/thing:2047554) (requires 4x 608 bearings) 1x [gridfinity grid](https://www.youtube.com/watch?v=ra_9zU-mnl8) (3x4 minimum size) (optional- works fine without... but why would you? I guess you could slice the bottom bit off the STL if you don't want to use gridfinity) NOTE: The f3d file is slightly buggy due to poor decisions. A lot of work was done in 3d mode just hacking off bits from Zack's template, and for some reason a few planes don't align precisely because of an odd rounding error. The STL prints fine. Any reasonable amount of infill will work.
Statistics
Likes
0
Downloads
0