STRUCTURAL BRIDGE
Description
This STRUCTURAL BRIDGE requires 2 prints for the main section, it takes 1hr-11m to print each side. The model has built-in BRIMS on either side to prevent any lifting, easily removed with scissors. The cross members can all be printed at once. I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of scrap printed PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on stryene and PLA for years. No sloppy or messy glue to show when finished. If you would like me to design a custom model for you contact me at: garylavart@yahoo.com. It is totally free but I will post it on Thingiverse for others to print and enjoy.
Statistics
Likes
0
Downloads
0