.36 Cal paper cartridge former
Description
This is a paper cartridge forming tool for 36. cal cap & ball revolvers. I looked around for a ready made model but couldn't find anything I liked and also most of them are for 44 cal. This was roughly based on the cartridge formers from GunsOfTheWest but I designed it from scratch. The tapered part is 25mm long and goes from 9.8mm to 8mm. The hole at the top is 10x13mm which is around 15 grains. I printed them fine however I couldn't test them with powder so please report back on your experience.
Statistics
Likes
0
Downloads
0