SanDisk Cruzer Blade - The Better Keychain Edition
Description
First Off, Credit Where Credit Is Due. Thanks To Nilsroe Here On Thingiverse, I Was Able To Create This. This Is A Housing/Casing For The Sandisk Cruzer Blade Flashdrive, Currently Intended To Be Used On A Keystone (Not Yet Made). However, Due To The Nature Of The 4Mm Hole At The End Of The Housing, You Should Be Able To Attach It To Any Keychain. Design Changes: - Extended Tail End To Accommodate Hole (Deliciously Centered). - Included Lid To Glue On The Other Side - Smoothed Angles On Transition Of Lower To Higher Interior Platform Of Main Housing Changelog: - 02.09.2017 8:35Am - Posted Version Just Broke, After Nearly Two Years. I'M Okay With That. Marking The Project As 'Finished.' - 04.26.2015 6:00Pm - By Lowering Entire Base, The Drive Housing Was Now Too Thick To Fit Into A Usb Slot. Oversight. Also, Pushed Rear Wall Of The Bed Back 1Mm, As The Bed Did Not Accommodate My 128Gb Blade Drive. - 04.25.2015 4:45Pm - Inner Bed Of Main Housing Wasn'T Thick Enough. Dropped The Bottom Of The Entire Housing By 1Mm, Should Be Good To Go Now. Not Yet Tested. Uploaded Separate Files. - 04.25.2015 2:00Am - As Of This Posting I Have Not Yet Printed This. I Will In The Morning. This Is Untested. Made Using Sketchup.
Statistics
Likes
43
Downloads
0