Kodak Carousel Projector Stuff
Description
Just a few things I've thrown together to connect up with a Kodak Carousel projector. These have been tested and work on the X00 (650, 700, 750, 760, 800, 850, etc), X00H (650H, 700H, 750H, 760H, 80H0, 850H, etc with halogen bulbs) and XX00 models (4000, 4200, 5200, etc) with the "swoopy design", as well as Ektagraphic models. The lens tube is to adapt a 70mm diameter macro lens to the front. This replaces the lens in the projector itself, and aligns the macro lens right in the center. The two connector models are to interface with the wired remote port on the back of the projectors. They're set up to fit molex pins crimped onto wires. I pulled wiring from a PC wire harness to use on this. I did need to split the pins open slightly to make them the right diameter for the Kodak connector. The light tube is designed so that if you remove the internal condenser lenses from inside of a projector (H models, specifically), you can mount this in there instead.
Statistics
Likes
0
Downloads
0