Halo strap for original oculus/meta quest
Description
All parts come in the orientation I printed it in, but other orientations could be better. On the comfort parts, the settings are Important. Firstly, use flexible filament. In whatever slicer you use (I use Cura), set wall and top/bottom thickness to 0mm, so it doesn't print any walls or floors. Set infill type to lines, and set the infill density to something that works well with your filament (I used 15%). On the hard parts, the settings aren't that important, use hard fillament. Use supports and infill where you think it is needed. I printed on 0.6mm nozzle diameter and 0.4mm layer height. On the soft parts, settings aren't all that important, just use flexible filament. When I use it, I remove the entire stock facial interface, and just push the headset closer to my face, it improves the FOV, but it leaks some light, I might make light blockers in the future. I recommend this, personally, I think the improved FOV is great for immersion, and having nothing around your eyes feels much nicer. I personally don't think the light leaking is that bad.
Statistics
Likes
0
Downloads
0