Ender 3 Heated Enclosure Relocate
Description
I didn't find anything that fit what I wanted for my new heated enclosure that would safely and effectively organize and house my electronics. I run Klipper and have a Meanwell PSU and wanted everything to be kept in the same part. This will use all of your cables, and your current power switch. Using some cable extensions like; https://smile.amazon.com/dp/B0784PQQFX?psc=1&ref=ppx_yo2ov_dt_b_product_details will save you some headache from re crimping the connectors. Four 12mm x 4mm magnets go into the bottom of the case, and some super glue will keep them in there. https://www.magnetsource.com/products/07046 You will need some wire and XHF connectors to extend your heater wire for the hotend and bed. https://smile.amazon.com/dp/B01ABOPMEI?psc=1&ref=ppx_yo2ov_dt_b_product_details https://smile.amazon.com/dp/B01ABOPMEI?psc=1&ref=ppx_yo2ov_dt_b_product_details Four M4-3mm Screws and eight plastic washers with a 4mm ID hold the PSU tight to the upper lid of the enclosure.
Statistics
Likes
0
Downloads
0