Tig Rod Divider for Small Opening Tubes - Blue Demon
Description
I have two of these plastic tig rod tubes purchased a different times from different suppliers. I think this one is made by blue demon and had a smaller lip on the inside of the opening 41.5mm to 42mm. This was made to fit that. It still required a small amount of the lip to be removed to install. I set the 3d printed divider on the ground then placed the welding rod tube face down over it and put most of my weight on it. After a bit of lip removal, it took a lot of force to snap into place. It is using the lip on the tube and the lip on the 3d part to lock in place. Its probably not ever going to pop out and that's OK with me.
Statistics
Likes
0
Downloads
0