Hex bits tray / holder for wall and pegboard
Description
This is a tray (not holder exactly, but tray) for 6.35mm hex bits for wall or inch pegboard (1 inch between holes, 9 inch size). This tray is **intentionally loose** (7mm) to get or put bit without any friction. **Do not adjust size to material shrinking**. There are 2 models: for wall only and pegboard/wall (9 inch hole-to-hole). 2 options: 4 rows and 2 rows. For pegboard sizes are: 8mm, 12mm, 15mm and 16mm deep. **My recommendation is 16mm deep.** Print with supports, but set to 46 degrees if your slicer want to add supports for 45 degree.
Statistics
Likes
0
Downloads
0