Anycubic Direct Drive mount for - Kobra max, Kobra plus, Vyper
Description
This mount is for a direct drive conversion on: Anycubic Kobra max, Kobra plus, or the Vyper Parts needed: Bondtech LGX extruder www.amazon.com/gp/product/B099NXJKPY Extension cable www.amazon.com/gp/product/B07QHTG82K (make sure the cables are in the correct order, look at the cable picture) ---------------------------------------------------------------------------- Cut a 95mm section of boden tube (Shown in the picture), and side into the hot end BEFORE bolting on the extruder and mount. Print the mount, use (4) M3 screws, (2) washers and (2) nuts to bolt in place. I suggest changing your retraction settings down to 1 or 2 mm's, the rest of your profile should be fine. Suggested print parameters: 4 perimeters 8 top/bottom layers 50% infil
Statistics
Likes
0
Downloads
0