v-tail quadcopter 40 degree motor mount
Description
This Is A Replacement Rear Motor Mount For A V-Tail Using Two 1/2 Inch Booms In The Back. The Frame Is The Batbones From Flitetest.Com, But Will Also Work With The Anycopter Variants. I Printed With 5 Perimeters, 200 Microns, 50% Infill With Pla. You'D Probably Be Better Off Using Abs As It'S Less Brittle, But It Will Just Be Another Breaking Point To Save The Motors If I Crash Hard Again :)
Statistics
Likes
11
Downloads
0