Manta MK2 For the Ender 6
Description
The Manta MK2 Ender 6 ------------------------------------------------------------------------------------------------------------------------ This is a remix of the Manta MK2 printhead for the Ender 5 that i have taken and modified to fit the Ender 6. The Goal: - modular and compact printhead - no loss to print area - part cooling upgrade I selected the Manta Mk2 as the base for this project due to its compact and versatile design for the Creality machines. Requirements: - Dual part cooling fans - BL Touch compatible - Adjustable fan height - No loss to print area - compact and light ------------------------------------------------------------------------------------------------------------------------ Print List; Print all parts included here using support from the build plate Align the Support Arm RH flat with the build plate, no support required **NOTE** if using a BL Touch - you can only use the mount I have included here, others will cause the BL Touch Sensor to contact the belts at the front of the Machine when traversing to Y axis 0 position The rest of the parts and instructions can be found here: https://www.thingiverse.com/thing:4945681 From there you will need to print the following parts to complete the print head; Stock_Clamp__Fan_Shroud_V1_1 (x1) 4010_Duct_RH_V1_1 (x1) 4010_Duct_LH_V1_1 (x1) Support_Arm_Bowden_LH_V1_1 (x1) Fascia_Plate_BL_Touch_Mount_V1_1 (x1) 4010 Blower Fans (x2) 3030 Fan (x1) ------------------------------------------------------------------------------------------------------------------------ Assembly: 1) Insert two M3 nuts into the back of the Duct Back Plate 2) slide back plate over Hotend mounting posts on the X carriage plate 3) install M3 x 10mm bolt into back plate to secure to carriage 4) install hotend on carriage 5) install x axis endstop onto back plate 6) refer to Original Design instructions for final assembly ------------------------------------------------------------------------------------------------------------------------ ** Final Notes ** To maintain full range of motion of the Ender6 you must use the above configurations for this print Head, use of optional 5015 blower fans will reduce travel on the Y axis. If using a BL Touch sensor you will need to update your firmware to the following; define PROBE_OFFSET ( 0, -35.714, -3.55) // ( x, y, z )
Statistics
Likes
0
Downloads
0