Flat Blade Wind Turbine Hub (6 Blade, 70 Degree Pitch)
Description
My rule is if you download this, you have to be subscribed to my YouTube channel! https://www.youtube.com/watch?v=3LJ35ep8rNE https://www.youtube.com/channel/UCQ9qxInZTJznj3O18qymalQ Recommended to print with high-ish infill and at least 3 walls. Lower layer height is recommended, as this is an aggressive-angle print. This propeller has two mounting holes, intended for use with plywood sheets or some other flat-blade material. The holes are 15mm from each other, and 12.5mm away from the edge, and can accommodate materials <3mm in width. The hub's shaft is made for a 5/16 bolt. I like using this type of design because I can replace blades of different lengths and widths to see what works best.
Statistics
Likes
0
Downloads
0