SV04 Bracket upgrade/ SV04 Upgrade...
Description
Designed a New bracket to use for the SV04 idex printer. Bracket allows you to use a E3D V6 hot end and the OMG V2 Dual Gear Dual drive Extrude (silver).I don't know if it works with other dual gear extruders. For direct drive only. You will have to use a dremel or something of the sort to remove the fins on the bottom side of the original SV04 bracket. This bracket attaches to the SV04 Mounting bracket, it cannot be used without. Fan mount is an extension of the fan mount for the v6. It converts the fan to use a 4010. I will submit a mount for the BLtouch sensor at a later date. It is approximately 56mm deeper than the original set point for the BLtouch.
Statistics
Likes
0
Downloads
0