HevORT HexTrudORT Nozzle cooler Berd Air CPAP Pump Anti-Vibration Mount
Description
After going through 3 original Berd Air pumps, it was time to move on to the CPAP fan and controller. This is my take on a mount. I used flex filament to create an anti-vibration mount. So it goes fan, spacer, flex mount, then cover. You could skip the flex and do a solid piece if you want. The flex piece is 5mm thick and I printed it at 100% infill, but it probably could be a little thinner and with less infill. The Fan uses M2.5 x 12 screws , the Controller uses M2 x12 screws and the vibration cover to hold the flex onto the mount uses M3 x 12 screws Remember to pull the fan wires through the slot and behind the controller card, BEFORE you mount the controller.
Statistics
Likes
0
Downloads
0