Planting Pot Cover
Description
These are cosmetic covers for typical 3-1/2" x 3-1/2" plant pots such as found in IKEA artificial plants and smaller live plant plantings, but are easily scaled to suit your application in your slicer. They may also be used as plant pots directly if you apply waterproofing to the interiors and drill drain holes in the bottom surfaces. This is a revised posting of a deleted object that I created some time ago, but also includes several new variants including a thinner walled version of variant number 5. Variant 5 in thin wall are the ones shown in the photographs. I deleted the original object because of some issues controlling the porosity of the clay pots that could be inserted into it (an item discussed as part of the original listing), **not **because of any problems with the item itself. They print fairly easily other than perhaps requiring a bit of support at the lowest edges and the side "vents" of a couple of versions, depending of course upon your printer setup and filament. You can easily waterproof the interiors using ABS juice, Flex Seal, or silicone RTV as you wish. Hint- Silicone RTV can be thinned with common naptha paint solvent to a consistency that can be brushed on like paint or poured in and swished around. 2-3 coats of material are recommended. I submitted this collection about a week ago and it appears to have been lost. So if this ends up becoming a double listing I will delete the earlier one. Thanks for looking at this collection and I hope they are of interest.
Statistics
Likes
0
Downloads
0