Air Assist Clip for 3018 CNC
Description
This is a clip which fits on my Sainsmart 5.5W laser module. There are two parts: the bracket and the nozzle. The nozzle is a separate part, for ease in printing, which I simply then stuck on with superglue. Using an M3 nut and bolt you can tighten the bracket around the laser module. Alternatively, I used an M3 heat-press insert instead of a nut. Simply push your air tube into the top and it should sit comfortably! The tube is 7.2mm wide (as my tube was 7mm) so should fit any tube diameter below that.
Statistics
Likes
0
Downloads
0