No Supports Stronger Ceiling Hook
Description
I liked the original hiding the screws but it had so many problems. 1) Original needed too many supports. This prints with no supports, the inside has been turned, the neck has been lengthen down to meet the bed, and the hook has been angled to print without supports. 2) when I screwed the original base in, the base would tend to spin around freely whenever I tried to put the hook on. This revision accepts two drywall screws so it can't spin. 3) If you put the original base in the hook to try it out, the base would become stuck. This revision has a platform on the base that can be used to take it off the hook. You can also use needle nose plyers on the two screw holes to help turn the base while inside the hook. 4) This is much stronger than the original. I printed this at 0.32mm with a 0.4 nozzle and it still turned out fine. Hook took about 23 minutes, base takes 5.
Statistics
Likes
0
Downloads
0