Prusa i3 MK2.5S/MK3S Extended Print Fan Support
Description
When upgrading my Prusa i3 MK2S clone to a MK2.5S, I realized the original Prusa print fan support (for the upper mount on the extruder for the part cooling fan) would not work, because the stepper motors I am using have a connector that must be wider than whatever Prusa use. Therefore, I used Tinkercad to extend the reach of the original part, by 5.25mm, to clear the connector. It worked. Hope this helps someone else!
Statistics
Likes
0
Downloads
0