Anycubic Mega part cooler, low restriction design for silent Noctua 60mm fans
Description
Designed for low airflow restriction, the feed neck going into the part cooler, has been widened to about double the original. The other airflow channels have also been extended and increased in volume, with 45 degree angles. This allows lower speed fans to move more air, without the higher static pressure (and noise) generated by a centrifugal blower fan. Intended for the Noctua NF-A6x25 fan: https://noctua.at/en/nf-a6x25-flx Works with any standard 60x60x25mm axial fan (with 50mm hole center spacing). The little dots/hyphens on the bed, in the STL file, are to prevent Cura from autogenerating tree supports there (will save filament), but supports are otherwise required on the sides, for the horizontal snap on arms. Original part cooler design: https://www.thingiverse.com/thing:2765158
Statistics
Likes
0
Downloads
0