Roborock H7 Wall Mount
Description
The Roborock H7 Pure stick vacuum did not come with a wall mount and a wall mount is not available for purchase. This wall mount can be wired to charge the vacuum when the vacuum is inserted or the wall mount can be used just as a hanger for the vacuum. Print settings that worked for me: 1) No supports 2) Layer height = 0.2 mm 3) Infill = 20% 4) Perimeters = 6 To wire the wall mount, you will need: 1) One large paper clip cut to two U-shape (see paper clip photo) 2) Two 10-inch wires 3) One 5.5mm x 2.1mm female power connector (usually available on-line for under $1) 4) Solder and a soldering iron Steps for wiring: 1) Push U-shaped paper clips through the 1½mm holes from front to back 2) Solder one wire to each of the paper clips 3) When looking at the back and right side up, attach the left paper clip wire to the positive (+) terminal of the 5.5mm x 2.1mm power connector and the right paper clip wire to the negative (-). 4) Run the wires in the recessed wire channel. 5) Push the 5.5mm x 2.1mm power connector into place at the bottom (see the picture of the back). Other suggestions: 1) There are three screw holes, I would suggest screwing the wall mount directly into a wall stud. The wall mount is fairly heavy with the vacuum on. 2) Depending on your printer and filament used, you might need to ream out the holes for the paper clips. You can use another paper clip bent so that a pointy end goes in the hole and the other end of the paper clip fits in a drill (see paper clip photo). After drilling out the hole a few times, the U-shaped paper clips should fit nicely. 3) Make sure the paper clips do not have a plastic or protective coating. You can scrape off a plastic coating or sand off a protective coating if needed. 4) The 5.5mm x 2.1mm power connector I used from Amazon: https://www.amazon.com/dp/B07C61434H?ref_=cm_sw_r_cp_ud_dp_QZCKN09G1J1VWY93CJK5 5) You can use tape to hold the wire in the wire channel, but it is not necessary.
Statistics
Likes
0
Downloads
0