Humidity Meter Holder
Description
I bought one of those Husky Waterproof bins to store my filaments and wanted something to hold the humidity meter by the lid so I can easily see when it's getting too high. That way I can tell when to replace the desiccants. I didn't seal the sides so I can slid the meter out easily if I need to replace the battery. Fits the Thermpro TP49 The two flat sides are dimensioned perfectly for the command large hanging strips (had to cut a little off the end cause the meter isn't as long as the strips. V2 has no vent holes for the meter V3 has the vent holes No supports needed, I printed with 15% infill
Statistics
Likes
0
Downloads
0