Beehive Ice Tray Remix 2 - Ender 3 or Aquila
Description
Hello! This is a remix made to fit on the print bed of an Ender 3 v2, Voxelab Aquila, or other knockoff printer. Print stays within 220x220. Printed in ~13 hours using default settings on Cura for 0.2mm slicing. No supports needed, works fine with PLA. Heat the bottoms to release the ice cubes if needed. I will probably remix these to make it thicker, as these cubes still thaw pretty quick (but much better than fridge ice!). I attempted to add a channel for leveling the water, will probably just redesign this in the future.
Statistics
Likes
0
Downloads
0