Filament holder modular
Description
this is a filament holder for all your filament spools! I used some standard 12mm tube to assemble the 2 brackets, I cut them at 1.2 metres. if you want to make it longer I suggest printing 3 of these and put one in the middle. I used a m5 threaded pin to clamp the tubes in the bracket, there is a premade hole for that. for the securing to the table i used 2 simple wood screws to hold it, the centre of the filament spool is right above the table so the screw doesn't need to be extremely strong -printed on Ender 3 V2
Statistics
Likes
0
Downloads
0